Measurements of ridge-cornice shingles are 1 m length, 33.3 cm width.          

We recommend to use ridge - cornice shingles as an initial row.  

A bitumen roof ridge/cornice tile is pasted along a ridge of cornice, on a metal part, a tile must be moved back from the margin of a metal part 10-20 mm. Remove a siliconised film from a bottom adhesive surface of a tile prior to pasting. An extra fixation of a roof ridge/cornice tile with nails is necessary. The butt strips are laid on spots of junction of pitches; their margins are fastened with nails and spread with bitumen mastic.

On spots of perforation the roof ridge-cornice tiles are divided into 3 parts and tiled with 3 - 5 cm overlap. Differently than in the event of cornice, the roof ridge tiles are tiled short sidelong towards the direction of a pitch.         

                  

 ATTENTION:

If you are going to put tiles at the outside temperature lower than -5°C degrees ir is reccommended to bent them on a heated 10 cm diameter tube in order to avoid cracks. In the cold season, shingles should be brought at the temperature more then +5ºC not less than 12 hours before use.